Cove Base Systems
Integral resin cove base — the floor carried 4–6 inches up the wall in one seamless, sanitary radius. The detail that separates a coated floor from a compliant one.
Request a Free EstimateWhat is an integral cove base?
Cove base is a curved vertical extension of the resin floor itself, hand-troweled or preformed to a 4–6 inch height and finished with the same coats as the field. The radius eliminates the 90° corner where dirt, water, and bacteria collect, so floor and wall wash down as one continuous surface — the detail USDA, FDA, and health-department inspections look for. We install cove as part of every washdown-grade system, including urethane cement and quartz broadcast builds, and can retrofit it to existing resin floors.
The corner that passes inspection.
- Seamless floor-to-wall transition — no joint, no trap
- Supports USDA, FDA & health-code compliance
- Radiused profile squeegees and washes clean
- Hand-troweled or preformed to suit the finish
- Same chemistry as the floor — bonds as one system
- Protects wall bases from carts, water & impact
Wherever walls meet washdowns.
Formed, bonded, finished.
Cove height and radius set to the facility’s code and cleaning requirements.
Wall base and floor edge mechanically prepared for a permanent bond.
Cove mortar hand-troweled — or preformed base set — to a uniform radius.
Field coats carry up and over the cove so floor and base cure as one system.
Topcoat seals the full assembly in the same finish as the floor.
Finish the system properly.
Adding cove to a new floor or retrofitting an existing one — tell us the environment and we’ll detail it to code.